Reflector and Aurora Materials Embroidery Badge Key Holder Within 80mm x 80mm (Set of 5) (#WAP-80-5)
One set of the same design comes with a ball chain of 2.4mm ball diameter for the number of key chains.
The back side is made of felt material 790 BLACK.
Reflector material (Gray)
Set of 5 6,000 yen / 1,200 yen per piece
Aurora Excution material (silver)
Set of 5 6,500 yen / 1,300 yen per piece
Aurora Reflector Material (Black, White, Pastel Pink, Pastel Red, Pastel Yellow, Pastel Blue, Pastel Green)
Set of 5 7,000 yen / 1,400 yen per piece
Color reflector material (yellow, green, blue, red)
Set of 5 7,500 yen / 1,500 yen per piece
*Stock quantity may vary depending on the supplier and may be out of stock after your order is placed.
This product is a set of 5 per design.
*Different designs and colors cannot be combined within a set of 5 pieces.
Please read the explanation about the key ring hole and select the position of the key ring hole.
Please submit data with cut lines.
Price includes processing cost for one set of patches (tax included).
◾️ ball chain can be changed to a colored ball chain
Color ball chain : 30 yen / piece
You do not need to have Illustrator or Photoshop software to submit design data.
Basically, Illustrator data, Photoshop data, JPEG, PNG, PDF, handwritten manuscripts, etc. are all acceptable.
If you are not familiar with file formats, please contact us.
Basically, large, full-size images are fine.
The key ring hole is 8mm in circumference and 4mm in diameter.
Please note that the size of the hole cannot be changed.
Please specify the position of the hole in your design.
Please mark the hole with *● or × and submit the design.
If it is difficult to include the hole in the design, we will set the position of the hole. (Refer to the basic position)
The cut line and the chain hole position are within 1/2
or within the edge
Cut line and chain hole position are more than 1/2 apart.
→ If they are more than 1/2 apart, there is a possibility of tearing.
Extremely large or small holes are specified.
→ The size of the hole is fixed at 4mm due to the convenience of re-creation.
*Depending on the position, there is a possibility that the hole and the design part may be covered.