Full color sticker (free within A4 size) (#STI-A4)

Please note that if the resolution of the data is low, or if the outline is anti-aliased, the opaque area will be judged as a design, and the white plate data will be generated for that area as well.
*White plates cannot reproduce translucent areas or gradations with transparency.
*Please note that there may be slight deviations in the print position due to the production process.

Price includes UV print processing cost (tax included).

Color mode of your submission: CMYK recommended (If you submit your design data in RGB, we will convert it, but the color will change slightly.)
*(If you are submitting design data, you do not need to use Illustrator, Photoshop, or other software.
(*Please use Illustrator only for path data when cut lines are specified.
We will do our best to accommodate submissions in formats other than those listed above, so please feel free to contact us.

Please keep your design within the "W200mm x H287mm" size, which is 5mm inward from the four sides of A4 size.
　Maximum design size: W200mm x H287mm
　Minimum design size: W30mm x H30mm (including cut lines)

If you create the cut line by yourself
　Please leave a space of at least 3mm from the design to the cut line.
　Please allow at least 5mm between adjacent cut lines.
　Due to the specifications of the cutting machine, cutting sharp angles can cause the design to be crushed.
　If there is a concern about reproducibility, we may adjust the cut line accordingly.

If possible, please separate the layers of the cut line and the design.
　Cut line paths (line width) should be 1pt (0.35mm) wide.
　If you would like us to create the cut lines for you, you do not need to create the cut line paths, but please make sure that there is at least 11mm between the designs.
　Please outline all fonts.

Please note that if the resolution of the data is low or if the outline is anti-aliased, the opaque area will be judged as a design and a white plate will be generated for that area as well, so the white plate may be printed slightly larger than the outline of the design.
　The white plate cannot reproduce translucent areas or gradations with transparency.
　Due to the production process, the print position may shift by up to 5mm.
Click here for submission template

If your order contains minor design differences, please share this information with us when you submit your data or place your order to prevent design differences during production and inspection.

We cannot cut stickers with fine cut lines and sharp zigzag angles. Rounded corners are recommended for a clean finish.
*UV stickers cannot be cut on the design of the filler due to the thickness of the ink. Only offset cutting from the design is possible.
*Please note that the cut line may be offset by up to 1.5mm.
*Cut line paths (lines) should be 1pt (0.35mm) wide.
*Be sure to connect the start and end points of the path (close path). Do not outline the cut path.

Separate the cut line and design layers as follows
Layer 1: Cut
Layer 2: Art
*Objects in the Cut layer will not be printed.
*Please be sure to place objects necessary for printing on the Art layer.

Please leave at least 3.0mm between the cut line and the design.
We can also create cutlines along the design. In this case, the cutline will be created 3.0mm outside of the design.
We may need to make adjustments if the cut line you submit is less than 3.0 mm.