Please note that if the resolution of the data is low, or if the outline is anti-aliased, the opaque area will be judged as a design, and the white plate data will be generated for that area as well.
*White plates cannot reproduce translucent areas or gradations with transparency.
*Please note that there may be slight deviations in the print position due to the production process.

Price includes UV print processing cost (tax included).

Recommended color mode: CMYK (If you submit your design data in RGB, we will convert it, but the color will change slightly.)
*Illustrator or Photoshop software is not required to submit design data.
(*Please use Illustrator only for path data when cut lines are specified.
We will do our best to accommodate submissions in formats other than those listed above, so please feel free to contact us.

Maximum design size: W60mm x H60mm
　Minimum design size: W30mm x H30mm

If you create the cut line by yourself
　Please leave a gap of at least 3mm between the design and the cut line.
　Since cutting sharp angles on the specifications of the cutting machine may cause the design to be crushed, even if a cut line is specified, if there are concerns about reproducibility, please adjust the cut line accordingly.
　If there is a concern about reproducibility, we may adjust the cut line accordingly.

If possible, please separate the layers of the cut line and the design.
　Cut line paths (line width) should be 1pt (0.35mm) wide.
　Please outline all fonts.

Please note that if the resolution of the data is low or if the outline is anti-aliased, the opaque areas will be judged as part of the design and white plate data will be generated for those areas as well, resulting in the white plate being printed slightly larger than the design outline.
　The white plate cannot reproduce translucent areas or gradations with transparency.
　Please note that the print position may deviate by up to 5mm due to the production process.

We cannot cut stickers with fine cut lines and sharp zigzag angles. Rounded corners are recommended for a clean finish.
*UV stickers cannot be cut on the design of the filler due to the thickness of the ink. Only offset cutting from the design is possible.
*Please note that the cut line may be offset by up to 1.5mm.
*Cut line paths (lines) should be 1pt (0.35mm) wide.
*Be sure to connect the start and end points of the path (close path). Do not outline the cut path.

Separate the cut line and design layers as follows
Layer 1: Cut
Layer 2: Art
*Objects in the Cut layer will not be printed.
*Please be sure to place objects necessary for printing on the Art layer.

Please leave at least 3.0mm between the cut line and the design.
We can also create cutlines along the design. In this case, the cutline will be created 3.0mm outside of the design.
We may need to make adjustments if the cut line you submit is less than 3.0 mm.